Apollo SL Installationshandbuch PDF herunterladen (Seite 31)

Installation

Apollo SL50 / SL60 Installation Manual

2. Press SEL (the selection field will start flashing), rotate the SMALL knob to make the

desired selection, then press ENT when complete.

The available serial port configurations are included in Appendix E.

Comm Radio Setup

The Test Mode settings may also be used to preset the Microphone (Mic) Gain and the

Receiver Squelch levels.

Mic Gain

Set the microphone gain for microphones 1 and 2 for values from 0 to 255.

1. In the Test Mode, rotate the LARGE knob to select "Gain - Mic 1."

2. Press SEL to activate selection. The Mic 1 value will flash.

3. Turn the SMALL knob to change the value.

4. Turn the LARGE knob to the Mic 2 value. Turn the SMALL knob to change the value.

5. Press ENTER to accept and save the settings.

Receiver Squelch

Preset the receiver squelch level for values from 25-100.

1. In the Test Mode, rotate the LARGE knob to select "Receiver Squelch."

2. Press SEL to activate selection. The value will flash.

3. Turn the SMALL knob to select a value.

4. Press ENTER to accept and save the settings.

Other Test Mode Pages

The SL50/60 test mode includes several other pages that are not necessary for the checkout.

They are as follows:

“TO TEST DISPLAY”.......................Can be used to check the SL50/60 front panel displays by

pressing ENT.

“TEST CONTROLS” .........................Can be used to check the SL50/60 front panel controls.

Press each button and rotate the SMALL knob to check the

controls.

“VDI T

RIANGLE”...........................Factory use only.

“OPERATION STATUS:” ..................Factory use only. Should be set to “STANDARD.”

“SYSTEM INITIALIZATION” .............Factory use only. Used to reset all internal memory

including user waypoints, flight plans, and configuration

data.

Caution: Using the system initialization

function will cause all user data to be lost!

“A/D C

H 1:” ..................................Factory use only. Used to check internal circuits and

display voltages.

“EEPROM BYTE 0000:” ...............Factory use only. Used to display eeprom setup memory.

“COM EEPROM BYTE 0000:”.......Factory use only. Used to display Com eeprom setup

memory.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Apollo SL Installationshandbuch Seite 31

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigatoren Apollo SL