Apollo 1550ETL Installationshandbuch

Stöbern Sie online oder laden Sie Installationshandbuch nach Toröffner Apollo 1550ETL herunter. Apollo 1550ETL Installation manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 23
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
APOLLO Gate Operators, Inc.
Model 1550ETL Single Swing Gate Operator
INSTALLATION MANUAL
04/07
Model 1650ETL Dual Swing Gate Operator
Seitenansicht 0
1 2 3 4 5 6 ... 22 23

Inhaltsverzeichnis

Seite 1 - APOLLO Gate Operators, Inc

APOLLO Gate Operators, Inc.Model 1550ETL Single Swing Gate OperatorINSTALLATION MANUAL04/07Model 1650ETL Dual Swing Gate Operator

Seite 2 - CONTENTS

101550ETL / 1650ETL Actuator OptionThe Apollo 1550ETL and 1650ETL systems – which use the 835/836 boards – comestandard with the 816E / 816EX actuator

Seite 3 - IMPORTANT SAFETY INSTRUCTIONS

11PUSH TO OPEN INSTALLATIONBoth measurements aretaken from the center ofthe hinge.11”6”Direction of openingGate (closed)Hinge postTop ViewVertical pos

Seite 4 - APPLICATIONS

12PROGRAMMING INSTRUCTIONSOnce the operator is installed or if the control board is replaced, you will need to program the controlboard for proper cur

Seite 5 - PRE-INSTALLATION CHECKLIST

13LED Enable & LearnMode Push ButtonOptional Device InputsStop Circuit JumperFire & ETL InputsEmergency BypassReverse Battery PolarityIndicato

Seite 6 - PARTS IDENTIFICATION

14Board Actuator Function CablePin 1 Orange Open LimitPin 2 White Close LimitPin 3 Black Motor (positive on open, negative on close)Pin 4 Red Motor (n

Seite 7 - OPERATOR INSTALLATION

15AdjustmentsPush ButtonsTIMER TO CLOSE Adjusts time before gate automatically closesAdjustable 5 to 70 seconds.DUAL GATE DELAY Adjusts delay between

Seite 8 - Actuator Installation

16Program SwitchesOFF ON1 TIMER TO CLOSE Gate does not automatically close. Gate automatically closes.2 TIMER TO CLOSE OPT. Gate automatically close

Seite 9 - IMPORTANT

17GND Supplied Battery GroundINP Activate Gate (Push button activation when momentarily shorted to ground)12V Supplied Battery Voltage (Protected with

Seite 10

18APOLLO Gate Operators, Inc.911 SirenMount siren in an area that will produce maximum performance (additional wire may be required).Connect the red w

Seite 11 - PUSH TO OPEN INSTALLATION

19APOLLO Gate Operators RECEIVER OPTIONSDo not confuse the receiver code switches with the red program switches on the gate control board.Never set al

Seite 12 - PROGRAMMING INSTRUCTIONS

2CONTENTSIMPORTANT SAFETY INSTRUCTIONS ... 3Applications ... 4Pre-Install

Seite 13 - Program Switches

20TROUBLESHOOTING OPERATOR & ACCESSORIESSYMPTOMSome troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may bep

Seite 14

21SYMPTOMGate will open using push button on side of box, but not with transmitter.1. Code switches do not match. Check that the code switches in the

Seite 15 - Push Buttons

22SYMPTOMGate will not open or close.Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts andne

Seite 16

23LIMITED TWO-YEAR WARRANTYApollo Gate Operators are warranted against defects for a period of 24months from the date of purchase, providing re

Seite 17 - Optional Device Inputs

3WARNING - To reduce the risk of injury or death: READ AND FOLLOW ALL INSTRUCTIONS. Installation should be performed by a professional installer.

Seite 18

4APPLICATIONSThe Apollo Model 1550ETL/1650ETL Swing Gate Operator is approved for Vehicu-lar Class I & II usage under UL 325 Guidelines, and is de

Seite 19 - RECEIVER OPTIONS

5PRE-INSTALLATION CHECKLISTThe following check list should be used before beginning installation:Verify that the proper operator has been selected for

Seite 20

6PARTS IDENTIFICATION#10025215Gate Bracket(2 with 1650)#1125Hardware Kit(2 with 1650)#404CAutomatic Battery Charger (optional)#2015 Watt Solar Panel &

Seite 21

7OPERATOR INSTALLATIONLocation of Pivot Point.1/2”Center Line of attachmentpoint for gate bracketHinge postVertical positionof pivot armMeasurements a

Seite 22 - Gate will not open or close

8STEP 3 Control Box InstallationMount the control box within 4 feet of the pivot arm.Do not mount the control box where the personusing the push butto

Seite 23

9STEP 6Limit Switch AdjustmentTo Retract MoreTurn Retract LimitScrew ClockwiseTo Retract LessTurn Retract LimitScrew Counter-ClockwiseTo Extend MoreTu

Kommentare zu diesen Handbüchern

Keine Kommentare