Apollo 1600 Anleitung zur Fehlerbehebung

 Gate Operators, Inc. Model 1500 / 1600 Swing Gate Operator  

CONTROL BOARD CONNECTIONS #633/634 Emergency Bypass Connector Used when the control board is not functioning. Unplug the motor harness from the Maste

633/634 CONTROL BOARD ADJUSTMENTS PROGRAM SWITCHES Factory Description Setting #1 ON TIMER TO CLOSE - Auto

PUSH TO OPEN INSTALLATION Both measurements are taken from the center of the hinge. 11” 6” Direction of opening Gate (closed) Hinge post Top View Vert

Gate Operators RECEIVER OPTIONS Multi-Code Allister Lift-Master Genie Heddolf Linear GND INP 12V GND INP 12V black gray

TROUBLESHOOTING OPERATOR & ACCESSORIES SYMPTOM Some troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may be

SYMPTOM Gate will open using push button on side of box, but not with transmitter. 1. Code switches do not match. Check that the code switches in the

SYMPTOM Gate will not open or close. Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and n

LIMITED ONE-YEAR WARRANTY Apollo products are warranted against defects for a period of 12 months from the date of purchase, providing

CONTENTS Safety Precautions ... 2 Applications ...

IMPORTANT - READ CAREFULLY BEFORE BEGINNING INSTALLATION •Read this installation manual completely prior to installation. •Installation should be

APPLICATIONS The Apollo Model 1500/1600 Swing Gate Operator is designed to handle swing gates up to 14 feet in length and 400 pounds each. A profess

PRE-INSTALLATION CHECKLIST The following checklist should be used before beginning installation: Verify that the proper operator has been select

PARTS IDENTIFICATION CAUTION Signs (2 each) (4 each with 1600) Gate Bracket (2 with 1600) Hardware Kit (2 with 1600) Automatic Battery Charger (option

OPERATOR INSTALLATION 6 Location of Pivot Point. 1/2” Center Line of attachment point for gate bracket Hinge post Vertical position of pivot arm Measu

STEP 3 Control Box Installation Mount the control box within 4 feet of the pivot arm. Use mounting hardware capable of supporting the weight of the c

8 Extend Limit Screw To Extend More Turn Extend Limit Screw Counter-Clockwise. STEP 6 Limit Switch Adjustment To Retract More Turn Retract Limit Screw