Apollo SL Installationshandbuch

ApolloModel SL30 NAV/COMMInstallation ManualNovember 1999 560-0404-00

Introduction2 Apollo SL30 Installation ManualFEATURESGENERAL FEATURES• 32 character high-intensity alphanumeric LED display• Sunlight readable full

IntroductionApollo SL30 Installation Manual3• Internal RF diplexor• Active and standby flip/flop frequencies• DME tuning an data displayCOMM RADIO

Introduction4 Apollo SL30 Installation ManualSYSTEM INTERFACESNAVIGATION RECEIVERThe SL30 can be installed in several configurations based upon indivi

IntroductionApollo SL30 Installation Manual5UNPACKING THE EQUIPMENTCarefully unpack the equipment. Visually inspect the package contents for any evide

Introduction6 Apollo SL30 Installation ManualOTHER REQUIRED MATERIALSThe SL30 is intended for use with standard aviation accessories. External devices

IntroductionApollo SL30 Installation Manual7LICENSE REQUIREMENTSAn aircraft radio station license may be required for operation of the SL30 Comm trans

Introduction8 Apollo SL30 Installation ManualNOTES

InstallationApollo SL30 Installation Manual9SECTION 2 - INSTALLATIONThis section describes the installation of the SL30 including mounting, wiring, an

Installation10 Apollo SL30 Installation Manual3. The valid flag sensitivity shall be 125 mV ± 10% for the flag to leave the stop and 260mV ± 10% maxi

InstallationApollo SL30 Installation Manual11Figure 2 - Mounting Frame AssemblyFigure 3 - Cable Routing

 1999 by UPS Aviation Technologies Inc. All rights reserved.Printed in the USANo part of this document may be transmitted, reproduced, or copied in a

Installation12 Apollo SL30 Installation ManualELECTRICAL CONNECTIONSThe SL30 installation kit includes 15- and 37-pin d-sub shells and crimp contacts.

InstallationApollo SL30 Installation Manual13MICROPHONE INPUTSMicrophone input connections should be made using a twisted pair shielded cable. Attach

Installation14 Apollo SL30 Installation ManualUSE OF SPLITTER AND COMBINERThe SL30 is the smallest, most advanced NAV/Comm unit on the market. Its siz

InstallationApollo SL30 Installation Manual15Dual Antennas and Dual SL30sIf dual SL30s and separate VOR and glideslope antennas are installed in the a

Installation16 Apollo SL30 Installation ManualFigure 5 - SL30 Comm Wiring Diagram

InstallationApollo SL30 Installation Manual17Figure 6 - SL30 Comm Typical Audio Panel Connections

Installation18 Apollo SL30 Installation Manual122 amp fuseor breaker+-AvionicsPowerPower +GroundNAVAntennaCoax cable to Nav anntenacapable of receivin

InstallationApollo SL30 Installation Manual19Rslvr{C}Rslvr{D}Rslvr{E}2472625123654Rslvr{H}Rslvr{C}Rslvr{D}Rslvr{E}Rslvr{F}Rslvr{G}Mid Cont MD200-306/3

Installation20 Apollo SL30 Installation ManualRslvr{C}Rslvr{D}Rslvr{E}2472625123654Rslvr{H}Rslvr{C}Rslvr{D}Rslvr{E}Rslvr{F}Rslvr{G}Mid Cont MD200-302/

InstallationApollo SL30 Installation Manual21Rslvr{C}Rslvr{D}Rslvr{E}2472625123654Rslvr{H}Rslvr{C}Rslvr{D}Rslvr{E}Rslvr{F}Rslvr{G}Mid Cont MD200-306/3

HISTORY OF REVISIONSRevision Date Description-- 11/16/99 Initial release (EN6278).IMPORTANT NOTE“The conditions and tests required for TSO approval of

Installation22 Apollo SL30 Installation ManualRslvr{C}Rslvr{D}Rslvr{E}2472625123654Rslvr{H}Rslvr{C}Rslvr{D}Rslvr{E}Rslvr{F}Rslvr{G}STEC: IND-351A+NAV

InstallationApollo SL30 Installation Manual23Bendix KingNav Converter andNav Indicator with Converter+GS Flag-GS FlagGSI DownGSI UpGlideslope Deviatio

Installation24 Apollo SL30 Installation ManualBendix KingIndicator with OBS Resolverwithout Converter+GS Flag-GS FlagGSI DownGSI UpGlideslope Deviatio

InstallationApollo SL30 Installation Manual25Rslvr{C}Rslvr{D}Rslvr{E}247262528323416VREFCOSSINOBS InSandel SN3308+NAV Flag-NAV Flag+TO Flag+FR FlagCDI

Installation26 Apollo SL30 Installation ManualSandel SN3308ILS Enbl 33NOTES: 1. Use shieled cable for resolver signals2. Connect cable shields to the

InstallationApollo SL30 Installation Manual27Navigation Indicator+GS Flag-GS FlagGSI DownGSI UpGlideslope +Flag303128321314+ RightNOTES: 1. Connect sh

Installation28 Apollo SL30 Installation ManualLIMITATIONS ON USING A COMPOSITE SIGNALIf an external converter is driven from the composite output in c

InstallationApollo SL30 Installation Manual29• NONE: No external resolver is supported. OBS mode allows the user to edit the OBSwith concentric knobs

Installation30 Apollo SL30 Installation ManualFlags TestThe Flags test in Setup Mode sends an active signal for each selected flag so you can test the

InstallationApollo SL30 Installation Manual31VHF NAV CheckoutOn the GroundCheck the VOR reception with ground equipment, operating VOT or VOR, and ver

NOTES

Installation32 Apollo SL30 Installation ManualAntenna CheckThe antenna Vswr can be checked using an inline wattmeter in the antenna coax usingfrequenc

InstallationApollo SL30 Installation Manual33Comm Flight Test CheckA flight test is recommended as a final installation verification. The performance

Installation34 Apollo SL30 Installation ManualAPOLLO SL30 POST-INSTALLATION CHECKOUT LOGDate: ___/___/___By: _____________CONFIGURATION INFORMATION:

InstallationApollo SL30 Installation Manual35INSTRUCTIONS FOR CONTINUED AIRWORTHINESSModification of an aircraft for the installation of the SL30 obli

Installation36 Apollo SL30 Installation ManualNOTES

SpecificationsApollo SL30 Installation Manual37SECTION 3 - SPECIFICATIONSThis section includes detailed electrical, physical, environmental and perfor

Specifications38 Apollo SL30 Installation ManualFigure 18 - Unit DimensionsAVIONICS OUTPUTSCDI L/R deviation...±150 m

SpecificationsApollo SL30 Installation Manual39NAV RECEIVER PERFORMANCEVORTSO compliance ...TSO-C40c (DO-196)Applic

Specifications40 Apollo SL30 Installation ManualGLIDESLOPETSO compliance...TSO-C34e (DO-192)Applicable documents .

SpecificationsApollo SL30 Installation Manual41Output signal voltage...0.390 VRMS (0.275 VRMS @ 90 Hz, 0.275 VRMS @150 Hz)

Table of ContentsApollo SL30 Installation ManualiTABLE OF CONTENTSSECTION 1 - INTRODUCTION ...

Specifications42 Apollo SL30 Installation ManualDuty cycle...100%Stuck mic time-out...

SpecificationsApollo SL30 Installation Manual43SERIAL INTERFACERS-232 ...Defined in Appendix E - Seri

Specifications44 Apollo SL30 Installation ManualTable 3 - Rear Panel Connector PinoutPin # I/O Connection Function1 I Power + Main DC power input2 I P

LimitationsApollo SL30 Installation Manual45SECTION 4 - LIMITATIONSINSTALLATIONFor minimum equipment and connections required for VFR or IFR installat

Limitations46 Apollo SL30 Installation ManualNOTES

TroubleshootingApollo SL30 Installation Manual47APPENDIX A - TROUBLESHOOTINGThis appendix provides information to assist troubleshooting if problems o

Troubleshooting48 Apollo SL30 Installation Manual• Software versions• Description of problem• Efforts made to isolate the problem• other installed

Periodic MaintenanceApollo SL30 Installation Manual49APPENDIX B - PERIODIC MAINTENANCEThe SL30 unit is designed to not require any regular general mai

Periodic Maintenance50 Apollo SL30 Installation ManualNOTES

Environmental QualificationsApollo SL30 Installation Manual51APPENDIX C - ENVIRONMENTAL QUALIFICATIONSThe Apollo SL30 has been tested to the following

Table of Contentsii Apollo SL30 Installation ManualSECTION 3 - SPECIFICATIONS...

Environmental Qualifications52 Apollo SL30 Installation ManualThe Apollo SL30 has been tested to the following environmental categories per procedures

AccessoriesApollo SL30 Installation Manual53APPENDIX D - ACCESSORIESThis appendix includes information on accessory items available for the Apollo SL3

Accessories54 Apollo SL30 Installation ManualNOTES

Serial Interface SpecificationsApollo SL30 Installation Manual55APPENDIX E - SERIAL INTERFACE SPECIFICATIONSThis appendix includes the interface speci

Serial Interface Specifications56 Apollo SL30 Installation ManualDATA FORMATThe data format for the serial communication is:• Baud rate 9600• Data b

Serial Interface SpecificationsApollo SL30 Installation Manual57MESSAGE DEFINITIONSINPUT MESSAGESRemote COMM Frequency ListsThe following two commands

Serial Interface Specifications58 Apollo SL30 Installation Manual3 = Air Traffic Frequency (ATF)4 = Approach (APP)5 = Arrival (ARR)6 = Automatic Weath

Serial Interface SpecificationsApollo SL30 Installation Manual59Message format:“V”... Message Class. This is a VHF NAV message.“20”...

Serial Interface Specifications60 Apollo SL30 Installation ManualMessage format:“V” ...Message Class. This is a VHF NAV message.“22”...

Serial Interface SpecificationsApollo SL30 Installation Manual61REQUEST DATA OUTPUTThis input is used to request an output message to be sent by the S

Table of ContentsApollo SL30 Installation ManualiiiSET ACTIVE VOR/LOC FREQUENCY AND RECEIVER FUNCTION...

Serial Interface Specifications62 Apollo SL30 Installation ManualSET ACTIVE VOR/LOC FREQUENCY AND RECEIVER FUNCTIONThis message is used to set the act

Serial Interface SpecificationsApollo SL30 Installation Manual63Example message:$PMRRV28?PM<chksm><CR><LF>This example command would

Serial Interface Specifications64 Apollo SL30 Installation ManualSET NAV AUDIO MODEThis message is used to change the current NAV audio mode. There a

Serial Interface SpecificationsApollo SL30 Installation Manual65Message format:“V”... Message class. This is a VHF NAV message.“41”...

Serial Interface Specifications66 Apollo SL30 Installation ManualMessage format:“V” ...Message class. This is a VHF NAV message.“21”...

Serial Interface SpecificationsApollo SL30 Installation Manual67Message format:“V”... Message class. This is a VHF NAV message.“22”...

Serial Interface Specifications68 Apollo SL30 Installation ManualExample message: $PMRRV24V1654<chksm><CR><LF>A valid bearing of 16

Serial Interface SpecificationsApollo SL30 Installation Manual69NAV RECEIVER STATUSThis message is used to output the current status of the NAV receiv

Serial Interface Specifications70 Apollo SL30 Installation ManualMessage format:“V” ...Message class. This is a VHF NAV message.“30”...

Serial Interface SpecificationsApollo SL30 Installation Manual71T = Transmit enabledS = Stuck micF = Comm failures... Squelch test s

Table of Contentsiv Apollo SL30 Installation ManualLIST OF TABLESTABLE 1 - PACKAGE CONTENTS...

Serial Interface Specifications72 Apollo SL30 Installation ManualNOTES

IntroductionApollo SL30 Installation Manual1SECTION 1 - INTRODUCTIONABOUT THIS MANUALThis manual describes the installation of the Apollo SL30 Nav/Com